焊機故障放電極起弧槍嘴不噴火
判斷可能是氣壓過大調節后仍不能噴火后檢查輸出氣電一體接頭膠木老化拆開后發現因為膠木擊穿
-
新聞詳情
判斷可能是氣壓過大…調節后仍不能噴火…后檢查輸出氣電一體接頭膠木老化…拆開后發現因為膠木擊穿…造成高頻漏于外殼！不能噴火…更換后正常！收工
It may be that the pressure is too big. After adjusting, it still can't fire. After checking the output of gas electric integrated joint bakelite aging... Apart and found that because of bakelite breakdown... Cause high frequency leakage in the shell! Can't spray fire... After the replacement is normal! Call it a day
等離子有高頻有空載不打火的故障很多 氣壓 高頻強度不夠 漏高頻 吸收電路 電路受高頻干擾等很多因素都會引起不切割
There are many faults in plasma, such as high frequency, no load and no fire. Many air pressure and high frequency intensity are not enough. Leakage of high-frequency absorption circuit and high-frequency interference will cause non cutting.